How To Light Pilot On Gas Fireplace With Remote. Always remove your fireplace glass prior to lighting your pilot * if you do not see a red or black spark ignitor button, you do not have a manual ignition system. Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot.
When operating from your valor wall switch, press the on/off. Lighting the pilot on a gas fireplace.for your safety, read before lighting:a. Push in the pilot knob, which manually sends gas into the system.
When You Are In The Off (Full Clockwise) Position, Rotate Clockwise (Approximately 1/8 Turn) To The Position Of The Pilot And Then Push On The Control Knob Completely Into.
Remember to do this when you are ready to ignite the pilot light of your gas fireplace. As you hold the control knob press the piezo ignitor button that will produce a “snapping” noise. Then, move the control knob to the “pilot” position.
Push In The Pilot Knob, Which Manually Sends Gas Into The System.
It should usually run parallel to the gas line when it is on. Right before your burner is the pilot light. This will make sure the pilot light stays on indefinitely, allowing you to activate the fireplace whenever you wish using the device’s wall switch or remote control.
Continue Pressing Down On The Knob, And Press On The Ignition Switch At Least Once Every Second.
You can light the pilot on a kozy heat fireplace by rotating the knob to the pilot position. While holding it down, you should hear the gas. How to light or relight a pilot on a gas fireplace, insert or stove.
Push And Rotate The Black Or Green Valve Control Knob.
Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot. With the pilot light ignited, turn your fireplace’s control knob from the pilot position to the on position. Make sure your main gas supply is on.
When Using Your Remote Control, Hold Down The Off And Large Flame Button Simultaneously.
How to light pilot on gas fireplace with remote. Continue to hold in the knob with the pilot lit for 30 to 90 seconds, or until such time as when you release the knob, the pilot remains lit. Here’s how to light a gas fireplace with a control panel.