How To Install Sharkbite Fittings On Existing Copper Pipe. Rotate the fitting if necessary to help remove it from the pipe. Now all you have to do is slide the sharkbite water shut off valve onto the pipe.
Clean the inside and first 1 inch of the copper pipe using a cleaning tool/brush. Furthermore, are shark bite fittings up to code? Use a generous amount of flux but not too much.
For Installation, Simply Slide The Sharkbite Onto The End Of The Copper Pipe And Tighten The Clamp Using The Provided Wrench.
Sharkbite fittings are approved by the uniform plumbing code and international plumbing code for permanent installation. Furthermore, are shark bite fittings up to code? To get started, identify the pipe material.
Insert Copper Pipe In The Suitable Sharkbite Fitting;
Click to see full answer. Be sure the pipe is free of scratches or debris and cut the pipe as cleanly and squarely as possible.measure & mark the insertion depth. 3 insert the pipe into the sharkbite fitting.
Sharkbite Fittings Are Used For Different Types Of Repairs.
Now use a repair coupling (has no pipe stops inside it). Insertion depth will depend on the size of the fitting. Slide it completely onto the pipe, install the short piece, then center the coupling over the joint.
In General, Sharkbite Fittings Only Leak Due To One Of These Reasons:
Avoid jagged ends with burrs. After it is cleaned, brush the flux onto the inside and outside of the male and female parts of the joint. Cut the copper pipe such that the ends are clear and sharp.
[00:35] Make A Second Cut To Remove Valve.
Use a generous amount of flux but not too much. Pipe insertion depth = 13/16 in. The pipe was not properly deburred prior to installation.